M42 Camera Body Cap (FUJICA)

M42 threaded, so should fit any camera body that uses the M42 Mount.
Although the label says Fujica.

Printing directions to ensure a good fit:

1. Turn off support structures
2. 0mm-5mm print at whatever layer height you like
3. 5mm+ print at 0.05mm layer height (for the thread)
4. Print from inside out (if possible) to minimize bubbles appearing on the outside of the thread.

Doge donations: D5cqNG1nHCRWeyFHv5LaJNrMP54MVyM2Az
Much appreciated!