Summary

This is a stand for the Switch Lite, which works with icefox1983's grip https://www.thingiverse.com/thing:4027345, and uses a USB-C extension cable to connect to the switch, allowing the original charger, or any other to be used to charge the console. It should also allow use of wired accessories while the console is docked. This was designed without any bridging or overhangs past 45 degrees, so it should be printable without support.

Print Settings

Printer:

SmartRapCore ALU

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20%</p></div></p>                                                    <strong>Filament:</strong> ???? PLA                Translucent Blue                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Settings shouldn't matter too much, just use what works best for your printer.</p></div>

Post-Printing

I designed this stand to use This extension cable From Amazon. The hole is slightly tapered so the end of the cable should slip easily in to the hole from the bottom, most of the way; it may need some force from a small blunt object the last couple mm to sit flush with the top. I included a clip that matches the taper inside the stand, which can be glued or press-fit in if necessary to hold the cable. I found it wasn't needed, but I included it anyway. The cable can then be routed through the channel out the back of the stand.

Switch lite charging stand