Summary

Cable Chain for X axis
Edit 10/03/14 : Adding support to avoid bending

Instructions

I noticed that the printer Da Vinci 1.0, the wire connecting the motor to the X axis bent at the same place, over time I think they will break.
I adapted the model of cable chain for Ultimaker on Da Vinci 1.0.
Once printed, you must remove the right panel of the printer, remove the clean box (two screws), disconnect the two plugs (sensor and motor), cut serflex (There it hits 3). Is careful not to cut a wire and check that it is not too tight when in place.
At your own risk
Print 0.2 mm
Use two serflex to attach the bottom end piece
Paste the 6 bottom link to avoid them moving
Any improvement is welcome

Cable Chain for Da Vinci 1.0