M42 Rear Lens Cap

A basic and smooth M42 Rear Lens Cap.
I've included an unbranded version and a Fujica branded version.

With the print settings below, it should print in about 1 hour and 30 minutes.
No support structures and no clean up required.

Print settings:

• Rotate model 180° for best print direction
• 0mm - 12.40mm @ 0.1mm layer height
• 12.40mm+ @ 0.05mm layer height
• Print layer direction is from the inside-out. (to avoid bubbles appearing along the thread)

Doge donations: D5cqNG1nHCRWeyFHv5LaJNrMP54MVyM2Az
Much appreciated!