49mm Lens Cap (Various Brands)

This 49mm Lens cap requires a spring taken from a twisting ball point pen (or also a clicker pen).
The spring should be about 4.2mm in diameter.

It's far from perfect, and needs a second revision to have a better fit (due to too much play in the clips), but it's good enough to go on a lens I don't use.

The Lens Cap comes with different branded options such as: Pentax, Olympus, Minolta, Fujica, and a blank version.

Printing information:
Cover_Body print @ 0.1mm layer height, with the main face orientated to the print bed.
No support structures needed.

Cover_Clip print @ 0.05mm layer height, with the finger grooves facing up.
Support structures needed.

Support structure config info:
support infill %: 34%
extra inflation distance: 0.30mm
dense support layers:0
dense infill %: 40%
print support every: 1 layers

Horizontal offset from part: 0.90mm
upper vertical separation layers: 3
lower vertical separation layers: 3

Doge donations: D5cqNG1nHCRWeyFHv5LaJNrMP54MVyM2Az
Much appreciated!