Summary

Cubex Cleaning the wipe III

Linear version

Instructions

After printing the parts, you should be very carefull in putting this in service.

You must test many times in MANUAL MODE before starting a new printing.

Print the parts in PLA.

1 - Abanador_parte_61.stl
invert the z position - can be printed without supports

2 - Abanador_parte_102.stl
you need to print with supports in another material (like ABS)

3 - empurrador05.stl
you can print without supports

4 - Suporte_nas_guias_parte_01.stl
necessary to change the orientation before print

5 - Put some aluminium tape in Abanador_parte_61.stl

6 - You need to buy the shaft (see image)

7 - You need a SPRING weak (I found one in a stencil) this could be the most dificult thing.

8 - Fix the empurrador05.stl with the back fan fastener - VERY carefull.................

9 - you need 2 fasteners and 2 nuts M4

....................................................................

You should verify the offset / wipe