SodaStream Watering Can Conversion

Have an old / warped / expired SodaStream water bottle lying around? Use this cap to convert it into a simple watering can.
NOTE: There is a small leak that occurs when you tip the bottle back upright... I believe that is because there is no rubber washer in it. To get around this I just wrap a paper towel around the neck of it. Might be able to find a washer to go around the neck.
I was able to print this design without raft or support, on a MakerBot Replicator 5th Gen with the standard profile. I only bumped "Infill" up to 20% to give it a little more structural integrity.