Summary

A model based on the yellow submarine
I have provided it in split for support-less printing, as well as full (needing support)

Not a perfect replica, but I am looking to make a small model.

Modeled in Sculptris

Instructions

Scale as desired, (small will hide my lazy modeling)
the split model will need to be glued together
Personally I prefer ABS for these situations, as ABS acetone glue-ups
work really well for me.
I have put both halves on the same build plate to allow scaling at one go.

my print was scaled down slightly split model
ABS
.15 slice
10% infill
80mm/sec
a few pinholes at these settings
glued with abs/acetone mix (syrup viscosity)
filled in holes by dabbing on the goop, set for 10 seconds
wipe off with a paper towel (repeat where needed)

Yellow Submarine