Summary

This is a box for the pieces of: http://www.thingiverse.com/thing:409284

Instructions

SettlersSW_box.svg is the file to laser cut. Make sure you set the layers up correctly for cut vs etch.

The half_sub_boxes...pdf's are for printing on paper or light card and cutting out - you will want to leave some tabs on the non-logo side to aid assembly. These can be used for holding the various playing pieces and should fit in the middle slot that isn't for rectangular cards.

You will need to add hinges to the lid.

When I cut mine the laser cutter had a bit of an issue so some cuts were recut once or twice so I needed to glue the ends, hopefully it should clip together sufficiently on a clean cut.

Box for Settlers of Star Wars board