1541 Mini remix

Thank you for the THE 1541 Mini Perifractic.
Perifractic did a great job , when printed the two pieces snap together perfectly.

This remix is to make it it more printer friendly and for some a better looking top piece, I have made the grid on the top piece and the top Logo a separate print.

Front Badge file can be downloaded from the remix source THE 1541 Mini Perifractic I'm not sure what is going on but the badge seems a smidge too big for the recess, the badge may need a slight trim or the file could be reduced a few percent before printing.

Supports will be required for the top piece.

I suggest printing the logo in a higher resolution with a small brim , by leaving the brim on it makes gluing the logo on much easier.

The base has not been modified in any way.

I've also updated the top piece with a little extra support for the grid cut out section.

21/09/2020 Added a tab stl , these can be super glued to the inside of the top piece to stop the unit squeaking when handled and makes fore a firmer fit, I used 12 , 5 either side and 2 on the back.