Nimble Rackmount for Amcrest AMPS5E4P-At-65 PoE Switch V1

Full build of the Nimble rack w/ BOM will be uploaded later.

Version 2 can be found here.

2U rackmount for an Amcrest AMPS5E4P-At-65 PoE switch to fit in a Nimble/six-inch rack.

I didn't have to remove the original casing for this one, but I was not able to re-use the original mounting screws this time. I tried, but the mounts were too thin and couldn't stand up to the torque when driving the screws. So, I made the mount points thicker and used M3x8mm screws instead. I tried to make mounts for all 4 of the original case screw-holes but for now, I'm just using the front two. (I'll probably fix this when I'm not so frustrated with it.)

For the side vent-holes, I went back to the 10mm hexagons and spaced them a little closer than the original pattern. After seeing the last shelf print, I didn't like how thin the space between the 15mm hex was.

I changed the bottom vents to a hex pattern purely because I wanted to. It was not necessary, and in no way improves the functionality of the piece.