Xiaomi Soap Dispenser Holder, Foam Soap, Xiami Mija

No special Print Settings.
For PLA i printed with:
Heatbed 60 °C
Extruder-Temp 215 °C

I used to mount it with sticky Tape (special one, for mirrors, especially in the bathroom).
Just clean off the flat back side and the tile in your bathroom with some alcohol.

Pro-Tip: preheat the tile a little bit, will evaporate last condesation of the tile so the tape will stick very good.

I also made on with a Hole, if you want to mount it with a screw.

Fitment:

The Holder cutout is designed to 73,3 mm diameter. After the print was ready i measured 72,6 mm diameter and it fits just right :)