FPV250 Landing Gear

This is my first attempt to make landing gear for the Diatone/Hobbyking/ 250 frame. I have designed these as part of a project to create an X8.There are 2 sets of legs depending on where you plan to mount them. These legs allow 6 inch props to be used on the bottom motors.

Middle legs mount to the spots marked in red.
Front/rear to the green spots.
Versions:
V1: Never got of the ground!
V2.0: First edition of current design.
v2.1: Added middle support where legs seperate.
v2.2: Added supports to top mount due to weakness discovered during printing.

NOTE: The middle legs will need the corners trimmed to sit flush with the frame (coming in v2.3)