Summary

My design of a credit card wallet coin slot. It is 2.8 mm thick (a normal card is 0.8 mm).
There is place for 3 bigger and some smaler coins, but you need a full compartment so that the coins do not fall out.
To assemble, simply run the rubber band with a knot on the end through the guides provided on the base. When that's done again tie a knot at the other end and glue the covering.

You need:

elastik band
glue

Print Settings

Printer:

Sidewinder X1

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.16</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100%</p></div></p>                                                    <strong>Filament:</strong> REDLINE FILAMENT PLA                Black                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Print both with the flat side on printbed; I recommend using the ironing fuction on cura</p></div>

Credit card wallet coin slot univeral