Pi-Boy V1.2

just a heads up for people DL-ing the V1.2 case, it is designed to have the compiste jack removed for it to work
I now included a Start/Select buttons, these are made for tactical switches

Update! V1.2
V1.2 is here! Changelog:
1.I found the case too tall, but I still wanted to keep the top retention, so i designed a clip to hopefully keep it in place.
2.D-pad stud bumped up 3mm

1. added "Adafruit's Pi-Boy Remixed" lettering, removed A/B(will return later, maybe) and made start/select lettering bigger.
2. added battery vents like the Original GameBoy
3. bumped the raspberry-pi's studs down .5mm.
4. closed up the direct power port and Ethernet cable port. for a more clean appearance

Like, share and feedback are appreciated!

This is a remix of Adafruit's Pi-Boy. I liked the original design but found it lacking in certain areas.
Improvements in V1.1:

1. increased top case lug size, doubling it to the point that you could friction weld it to side of the case if you find it lacking.
2. made the case taller to allow two more lugs to be used. helping the top of the case to stay together.
3. added the writing on the top of the case (YES I KNOW A AND B ARE BACKWARDS AS ARE START/SELECT. THIS IS MY PREFERENCE!)
4. Adjusted the height of the control lugs, I am using tactile switches instead of the SNES controller as i found it impossible to get the pads of the soft keys to line up. plus the tac switches have a better break point.