Summary

Holder for contacting a set of 12 contact pads with 12 pogo pins (0.1''/2.54 mm pitch). Held together by 3 pairs of 4 mm diameter magnets that were superglued in place after insertion.

pogo pins: https://www.mill-max.com/products/socket/816-xx-xxx-10-003101
magnets: https://www.supermagnete.de/eng/rod-magnets-neodymium/rod-magnet-4mm-10mm_S-04-10-AN

Print Settings

Printer Brand:

Ultimaker

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p><a rel="nofollow" href="https://ultimaker.com/" target="_blank">Ultimaker 3</a></p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>200</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20</p></div></p>                                                    <strong>Filament:</strong> Ultimaker Nylon                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I found that printing without support with the blind magnet holes open-side-down produced the best results. Good luck!</p></div>

Post-Printing

Magnetic pogo pin holder