Summary

Revised version of Duran's iPhone 6 blank case and sized it to remove a bit of vertical slack the original had and I split it in half to fit nicely in my Up! Mini.

Instructions

Recommend printing in PLA at 0.2mm layer height or smaller with no raft and minimal supports to ensure easy removal.
v1.1 - updated the top half to remove the need to put any pressure on the power button. Assemble by pushing the lower half onto the phone first, then slide the top half on from the volume button side, then clipping over the far edge where the power button is.
Note the sections are a very exact fit when printed on the Up Mini so you may need to push gently on them to align and let the pieces lock together. Alternatively use a craft knife and run around the inside edge of the locking tabs to give them an angled edge to slot in.

iPhone 6 case in 2 parts