Summary

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/7t0VmBQPj1k
This is my final version of a bed stabilizer for my Solidoodle 3

Instructions

A small compression spring approximately 1.5 inches long is centered and pinned in place thru small hole in center section. 2 11 x 5 x 4 mm bearings are held in holders by plastic pins. 2 3/16 inch steel rods are cut to approximately 5.25 inches 1 end is ground down to fit in bearing holders . 2 screws threaded into center section keep it tight on build bed base.

Build Bed Stabilizer V 3