Summary

I made some modular pieces for another project and decided to re-use them and make a phone stand out of them. You will need to print four corner brackets and three middle pieces and one of the two phone holder pieces.

The tolerances on the pieces are tight enough that they will stay together on their own, but not too tight so you can pull them apart if needed.

The corner pieces have threads for M4 screws, they were used on my previous project but not on this one.

Print Settings

Printer:

Ender 6

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>12</p></div></p>                                                    <strong>Filament:</strong> Other PLA                Slate Grey                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Supports are only needed on the corner pieces and the phone holder.</p></div>

Modular Phone Stand