Compact, lightweight case for Ublox 6M gps in 35mm size

This is a light-duty case for the 35mm board size Ublox 6M gps module (with compass) that I bought from Witespy. The case clips closed, but you'd probably be wise to add some adhesive or tape if you fly as badly as I do (I use it on a quadcopter).
This design is obviously for external wires... most people would probably mount this on a stalk and curl the wires around it down to the quadcopter controller board.
I also slapped together some files for some easy stalk mounts (i.e to mount this thing on the end of a rod to keep it away from the other electronics on your quad). I have not used them, or even printed them at all, so hopefully they work. Just stick them to the bottom of the case using adhesive or double sided foam tape, velcro, etc.
My 35mm size GPS module fits very tightly in this case. Best to fit it into the top section first (make sure the antenna panel points into the case, of course), then put the bottom section on. I modeled some starter holes in the corner pieces if you're the type who likes to use screws. I have not tested these at all, but obviously, the holes would need to be drilled through the case top or bottom.