KRG X-Ray Angled Bag Rider

A printed angled bag rider specifically made to fit the Gen. 4 KRG X-Ray chassis stock. Helps raise the rear end slightly when using a fully extended 6-9" bipod with the ability to adjust the height by moving the rear bag forward/backwards.

Hardware required:

(2) M5 x 0.80 mm x 10mm button head/pan head screws

Printer Settings: (0.4mm nozzle)

• PLA/PETG/ABS
• 0.2 - 0.28mm layer height
• 3 walls/perimeters (minimum)
• 3 top/bottom solid layers
• 15-100% infill, gyroid infill preferred
• No supports
• Printed on its side flat on print bed

Use instructions:

Attach to KRG X-Ray mounting points on underside of stock using the two button head screws, tighten using an allen key through the holes on the bottom side of the bag rider.