E3D V6 Bowden Printrbot Simple

Have not tested yet, my E3D V6 is in the mail and I am going to try the bowden model. The bowden connector is mounted directly to the hot end and I could find no mounts that did not have the tube connector going directly into the mount I modded on already here to remove the bowden tube portion of the mount so the top of the Hot end would be exposed to the tube. When I get it pictures will make more sense of this. I am very amateur at modeling so if anyone can help.... I also added a hole for a nut to go into the third hole in the mount so the rear of the clamp can actually be tightened down.
UPDATE:
I printed with nylon bridge and it works perfectly!!!