Summary

For your annoying wire management needs. This will help keep the spiral cable wrapped wires away from your prints. If you have a fan shroud you will run into issue where the screws will be to short. 3njoy

Instructions

Very simple print, Just print at your settings and you should be all set. To secure the cable to the holder two zip ties can be threaded through the holes and secured.

If you have a older model simple metal where the fan bracket does not cover the whole fan you have two options, 1. you can use the MK4 model and the MK4 spacer. The spacer rests against the fan and the bracket rest on top, then secure with all four fan screws, 2. there is a MK4 model with the spacer built on, just one piece.

If you use the MK4 feedback would be nice so i can adjust it if needed. I have the newer model so I cant test the fitting myself. Thanks

Printrbot Simple Metal Wire Holder