Bulbasaur Halloween Witch Hat - Fitted

I started with the original .stl of this Witch Hat (included). I then modified the scale and added a cut to the bottom to fit the Bulbasaur head of the Thingiverse model linked below.

This hat is intended to be printed alone and then fitted to the head of Bulbasaur with glue. I used PLA and Superglue (CA) with great success.

Lay flat on print bed, brim has two large flat spots, and print with 100 percent infill. I find this to be a good decision on this model as the difference in material and print time is quite negligible for attaining a solid print.

Note: The original hat was not designed by me. This is a model that has been roaming around for about ten years it appears with no certain attribution right now. So, I give this as a remix of unknown origin.

Made to Fit in FreeCAD - High-Poly Bulbasaur: https://www.thingiverse.com/thing:1576163