Summary

This is a carrier for an additional bit-magazine and a lenght-extender (file: SD_Halter.stl). And it is a bit-magazine, that is identical to the original design (file: Magazin.stl)

Instructions

Carrier:
I ptinted the carrier in ABS (thickness: 0.25 mm - fill:85 %).
Put a 6 mm magnet into the hole from the back.
Unscrew the two screws on the sides of your WORX (see pictures) and mount the carrier with these screws (they are long enough).

Magazine:
I printed the carrier in ABS (thickness: 0.25 mm - fill:85 %).
Put the pin into the center hole of the magazine, then a thin spring (4-5 mm long), then a 6 x 10 mm magnet (round) and finally clue in the plate to cap it.

WORX WX254.4 SD SemiAutomatic Bit-Changer