Summary

30 teeth MXL plotter pulley for drive any 3D printer with low cost plotter pulleys 8â‚¬/4meters

Instructions

print at 0.15mm layer height and 90%infill, in the drowing i have considerate the melt plastic distortions, i have printed 3 at time because i dont usa fan, and work perfectly :) the MXL_pulley 2 have the distance between teeth 0.3mm down if you have problem with v1 try print v2

i have added a belt splitter too, if you dont like 10mm belt you can split into 7mm belt, just print the belt splitter(print 2 parts) , couple it and fit the belt into it, then insert a sharp, i have leaved 3 spaces for 5mm, 7mm and 9mm large belt.

you can use these 3 meters belt: http://goo.gl/yhyfp only 8â‚¬ :)

mission done :P

30 teeth MXL plotter pulley up to 10mm belt for reprap