Proton Pack Cyclotron

UPDATE 2/12/17. This part was used in the Ghostbusters Station 6 fan film. Check it out on youtube at https://www.youtube.com/watch?v=RHMUsQqLmRg

RE:UPDATE 4/12/15 New mount will need holes for self tappers to be drilled into the bottom of the cylo. I will make changes to fix this soon.

UPDATE 4/12/15: New cyclo mount added. This is an improved, single mount over the 4 separate ones previously and aligns with the holes in:
https://www.thingiverse.com/thing:1093376
I need to update the cyclo bases to match the holes in the mount, or in the meantime, use a 2.5mm drill with the mount against the base of the cyclotron as a drill template.

A full size, 3D printable version of the Ghostbusters' Proton Pack cyclotron based on Steffan Otto's plans at:
http://www.gbfans.com/wiki/Stefan_Otto%27s_Prop_Plans
Print two copies of CyTopWide.stl
Print two copies of CyTopNarrow.stl
Print two copies of CyBottomWide.stl
Print two copies of CyBottomNarrow.stl
Print four copies of CyDisk.stl
Optionally print 4 copies of LedDiffuser.stl in clear PLA. This fits a
5mm LED.
Join bottom parts together using M4 nuts and bolts.
Push CyDisks through CyTop holes, then fasten to CyBottom from
underneath with 5/8"x#3 self tap screws.
Print drill.pdf onto A3 paper at 'actual size' for the drill centres for
holes.
Print 1x CyBottomNarrow.stl and 1xCyclo-NFilter if you plan to
use my N-Filter at:
http://www.thingiverse.com/thing:543816

UPDATE 20/11/2014: Added pillars to allow the cyclo disk to fasten directly to the motherboard. See CAD rendering for details.