Summary

A strain relief that is mounted on the extruder motor. It keeps the extruder wires nice and tidy too! Requires no disassembly.

Instructions

Print 1x usr_main and 4x usr_tips. You will also need 4x M3 nuts and bolts, and 3 zip ties.

Push the nuts into the nut traps and screw in the bolts. screw the tips onto the ends of the bolts. Pull apart the two ends of the main piece and thread the motor wires through. zip tie shut the two ends of the main piece and fit it over the motor. Tighten bolts until it stops moving (don't over-tighten).

If it doesn't fit, flip it over.

Universal Extruder Strain Relief