Summary

Part in progress

This a system to get a telescopic pole.
All the parts are now available

Instructions

Parts you'll need:

Instructions:

After you've printed all parts.
You can screw the shaft (green) in the cone (blue)
you put the red part
then you put the "small" tube (where you made 2 snick)
You assemble the pink part around the turquoise wheel 1 named "molette inter.stl"
put the 6mm nut
close with the part named "molette inter.stl" and with the ' wood screws
screw the set on the shaft until the the pink part come over the small tube. And STICK the pink part on the tube (with ABS solved in acetone for exemple).

and here it is