BI 2.5 Inexpensive enclosure 2.5

Ok so here's an inexpensive enclosure I designed. I was going to use plexi-glass for this design but I wanted to keep it inexpensive so just cardboard & some Neodymium magnets from home depot ($7.50 for 12) where used. I found there are a few different sizes of these magnets so there is 2 different size imprints to help accommodate this.. use what one fits the magnets you can find. The panels were made to tip out at the top for easy removal & installation. I used some glue to place the magnets & added a handle to the front panel. I included the panels for size but as every printer is different.... so will the size of your panels. I added a stock tool holder for one of the lower corners. UPDATED: 1/14/15 I still need to make some flaps to fill the gap at the bottom sides & gopro mount.. will post when I can get to it.