Summary

Keep your antenna in place at a nice 90 degree angle

READ INSTRUCTIONS PLEASE!!!

Instructions

0.01mm Layer Height!
100% Infill
No Supports
2 Shells
Slow Feed Rates!, max 50mm/sec for infill

Preferably print with ABS, but I used PLA. PLA is alot more work because it wants to stay liquid when printing small detailed parts like this. If you use PLA you will have to keep a hair dryer ON COOL (NO HEAT) on the print while it is printing the final 20% because there is an overhang that will need to immediately cool when it lays down. If your print head temp drops below 175 C stop with the hair dryer and wait for it to go back to at least 190 C before you start again.

Circularly Polarized Antenna Cast