Summary

A cute snowman with some more "accessories" added.
It is aimed to be hanged in the Christmas tree, but you can use it foe whatever decoration you can imagine.

Instructions

Print it in "vase" mode, with or without bottom layers.
For a 0.4 mm nozzle, use 0.1 mm layer height and 0.6 mm extrusion width.
Print at 60 mm/s and add cooling for rapid layers.

If you want to use it in the Christmas tree (or otherwise hang it): Normally, a small hole will remain on top. If not, drill one (1 mm will suffice). Use 20 mm length of 0.5-0.8 mm wire (an electronic component pin will be great) to prepare a hanging ring (see pictures). Push it gently through the hole and that's all.

Snowman 2014