Summary

This is my overbuilt mount for the L-cheapo V2 laser cutter. Designed to fit with my E3D V6 hotend mount still in place.

Instructions

NOTE: I have tested this for fitment but haven't actually used it for cutting yet.

I printed mine in PLA at 0.2mm layer height and 100% infill. Don't forget to remove it when not in use because the heat from the bed during a print could cause it to sag. The hole just above the slot is so you can put a screw in from the bottom to hold the heatsink in place. Alternatively, you could glue it or something. The fan is meant to be held on with zipties for convenience.

Rigidbot mount for L-Cheapo V2 laser cutter