Slimline Floppy Drive Enclosure (Rev. 6)
This is revision 6 of my Slimline Floppy Drive case, which can be used with both the DrawBridge PCBs that I make, but there's also enough room in there to fit an Arduino Pro Mini, Nano and an FTDI board if required.
I printed these at 0.2mm layer height without support. 50% infill in PLA.
The top and bottom slide together and with the help of a small screw can be anchored in place. As you can see from the photos I've printed quite a few of these!
If you want to chagge the design, then [here's the links to TinkerCad where I designed them]
(https://www.tinkercad.com/things/bMMy1aB4F6e-drawbridge-slimline-box-rev5)
The PLA's I used are: (Affiliate links)
Beige (Bone): (https://amzn.to/41qhRn2)
White: (https://amzn.to/416oxqt)
Blue: (https://amzn.to/41brINS)
Black: (https://amzn.to/406GdRE)
The Beige one is close to the cream colour of the original Amigas
Enjoy