Kamen Rider OOO Medal Rim Remix

This is a remix of the Core Medal Rim model from here. In the original version, you need to print two of the core medal rims and glue them together to put the fronts and backs in, but I wanted a version where the rim was a single piece that you could snap the fronts and backs into. So here it is!

My medal rim remix is sized to fit most of the medal fronts in the link above as they are. The medal backs are smaller, and should be sized up 200% on the X and Y, but NOT Z. (I think some of the bird medals are also the same size as the backs and should be sized up to 200%.) I also found in my printing that to ensure friction fit, the fronts of the medals may need to be sized up to 100.5% or 101% on the X and Y. (TLDR, the X and Y for the core medals and backs should be around 36.5mm in your slicer for a proper friction fit. If they come out a touch too small for the rim, you can glue them together without much issue.)

I am not sure if there is still enough clearance to install rfid's and use these with the scanner, so if that's something you're concerned with, experimentation may be needed.