Summary

Wooden train track to go down Stairs

This was designed to allow the track to be easily angled to go down (and up) stairs, the top piece section is design so you can tape it to the floor to stop slipping and the connecters were designed to stop pieces slipping through (there are other ways to do this as well).

This is designed for statis at an angle of 38.05 degrees but may allow for similar angles.

Print Settings

Printer Brand:

Prusa

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>I3 MK3S</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.15mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>15%</p></div></p>                                                    <strong>Filament:</strong> eSUN and Tecor PLA                Any                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Train_stairs_top and Train_stairs_bottom were printed on there side and printed with supports.</p></div>