Summary

In order to prevent fumes in your work area here is a vent that conveniently fits over the finger hole of the Flashforge Creator pro

Instructions

over all this is easy to do don't let my instructions make it seem otherwise.

This is designed to attach to a 4" dryer vent hose, and a fan to flow the air out. I used an old fan from an old projector the model DSB0624H (I was able to find a similar one from Mouser.com) or just keep the inside fan diameter around 57mm. If the small screw holes don't fit just use silicone. To hold the vent adapter to the printer I designed it to be non-damaging to the printer my using tension to hold it on. On the inside of the printer use then wood with screw slightly longer than 1.5mm radius, because that is the radius of the screw hols.

PS use tape to help seal the printer box just to help prevent air flow, and plastic wrap where the cables go in to the printer.

Vent, Flashforge Creator pro finger hole vent