Summary

Auto Bed Leveling adaptation for BQ Prusa I3 Hephestos

Video's showing in action.
Start: http://tinyurl.com/otbwco2
Ending: http://tinyurl.com/qzhvrfw
Testing arm: http://tinyurl.com/lrdk7qk

Connections: http://tinyurl.com/qcmdhko

Instructions

You will need one micro servo digital or analog, 90º or 180º and one micro switch of your choice, i did use one "SS-5 MICRO SWITCH", and some cable extensions for the servo and for the micro switch.

Remember to print this part's in ABS.

You will have to disconnect / remove Z end stop and connect this micro switch.

I did replace as well the table springs by some printed 1Cm spacers.

Video's showing in action.
Start: http://tinyurl.com/otbwco2
Ending: http://tinyurl.com/qzhvrfw
Testing arm: http://tinyurl.com/lrdk7qk

Connections: http://tinyurl.com/qcmdhko

On the video you can see that the table have more then 5mm difference in on side, this was just to confirm that the auto bed leveling was working correctly, the part that is printing was one of table spacers.

Enjoy!

BQ Prusa I3 Hephestos auto Bed level