Summary

This is a hanger for hand-held shower head.

3/8/2018 -- Updated to handle a different shower head with thicker dimensions.

Instructions

My shower wand T-joint/valve/switch failed, and when I purchased a new one, there was no option for attaching the wand to it, as the former one had provided. So I created this hanger as a substitute.

This hanger is printed in two pieces. I used a small bolt and 2 nuts as a hinge and then spray painted it with metallic silver to match the wand.

NOTE: My printer was not very good at printing the overhanging bevels of the up curving base. The images are shown after substantial trimming of rough edges.

EDIT: (3/8/2018) Updated design should be printable without support, as long as printer can handle 45 degree overhang.

Shower Wand Hanger