Play Doh Rolling Pin with Interchangeable spacers

Here is a Joseph Joseph type Rolling Pin for Play Dough. I have provided 8 Spacer sizes. Only one spacer per side is typically used when in use.

There are 2 bolt designs. I would recommend doing the bolts at 100% infill for strength.

One design is a bolt that can be printed without support, and a bolt head that will more than likely need support. This design provides a cleaner print, but will require that the 2 pieces be glued together. I used 5 minute epoxy to glue them together.

The second bolt design is a single one piece part that is oriented to be printed on its side. This will require support and may need a little cleanup of the bolt threads so it screws easily into the rolling pin.

I have also included a Rolling Pin Stand so the rolling pin does not roll off the table when not in use.

The Bolt Head was a nice design borrowed/remixed from https://www.thingiverse.com/thing:4848480

I also have some Peppa Pig Play Doh Stamps at https://www.thingiverse.com/thing:6227747

Hope you enjoy.