Summary

A TALL Brio track/bridge support, for a 2nd layer of elevated track. It is designed to allow lower levels of track to pass under it.

Print using supports, with the part upside down.

I printed mine using PLA, but I suppose any material would work except perhaps the very softest flexible stuff.

Print Settings

Rafts:

No

                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>any</p></div></p>                                                    <strong>Filament:</strong> any PLA                any                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Print upside down using supports.</p></div>

How I Designed This

I designed this using Tinkercad.

The model in Cura from Tinkercad

2 Tall supports with a straight section of track

Blue tall support

Red tall support

TALL Brio Bridge Support