phone stand with heart

The challenge of this print is the use of tree support ... and support. I ve been watching a youtube video before setting up the support interface. I used the settings of the first video below.

https://www.youtube.com/watch?v=3WJAR9-waco

https://www.youtube.com/watch?v=iYtlrqmIy3o

https://www.youtube.com/watch?v=7BURpQNXrDA

https://www.youtube.com/watch?v=wC6lMTSlZjU

https://www.youtube.com/watch?v=ts-hTCBqFpE

The result :

• the model did print the first time (it s important for me after 10 hours of slow printing :-) )
• support were removable with a plier and careful force
• quality was slightly better than the standard support i was usually using (i dream of a perfect smooth quality, but i m still so far from it)
• the tree solution is elegant and save PLA : so, good.