Air Brush Turn Table (turntable) / Lazy Susan (lazysusan)

Wanted a larger Turn Table than any I found in a few pages of searching!

Pretty much takes up table of Ender 3 / 5

608 Skateboard / fidget spinner bearing.

included a test of the top so you can test the scale of pressing the bearing into the top as it is roughly 18 hours on my settings (running pretty slow 5 walls)

I have not used yet, the Top V2 is on the bed now.
The base MIGHT be a bit small, if so I will include a larger set of legs and maybe even taller as needed.

Added a new Base, larger feet and peg for bearing is a bit bigger, i sunk it -9.5mm below base to test print, took about 20 min x 2 getting my settings good, depending on your printer you can scale up or down a couple percent if things do not fit as well for you.