Frankenquest Meta Quest 3 DAS

The original model was way too short to fit on my Quest 3 for some reason.. this one is lengthened by 1.8mm

Instructions for installing:

1. Clip the DAS into the adapter FIRST
2. quickly dip the adapter with the end of the DAS into a cup of boiling hot water.
3. Shake off the water and quickly snap on the quest 3 while the model is still soft.

If you do it the other way around and shape it to the quest first and then try to clip on the DAS it may not fit.

Shaping the model with heat is only going to work well if you print with PLA