Square 20mm (LTT) Bit Holder

A square, lower volume version of the original.. with magnets!

Had 1 too many instances where a few, or all, of the bits would fall out in my bag. 1 magnet is more than enough to hold the bits in, even when being shaken upside-down. Use 6x2mm magnets. Only 1 magnet is needed, but I've included models for 0-2 magnets. (All versions in the .blend file as well)

I recommend alternating polarity when laying out the magnets, so 2 cases can be attached to one another. ¯\_(ツ)_/¯ Cause why not.

Example magnet layout (make sure all holders match):
🟢🔴🟢🔴🟢🔴🟢🔴🟢🔴🟢🔴
🔴🟢🔴🟢🔴🟢🔴🟢🔴🟢🔴🟢

Includes versions with the names of the bits sold by LTT engraved in the top and sides of the outer shell.

A template version can also be found in the .blend file if you're familiar with blender. Just edit the Text using tab, convert to mesh, boolean difference, done.