Summary

Changes of this remix:

Removed one separator to only have two sections.
Also reduced wall-thickness.

The desired width of the drawer is about 3 millimeters bigger, than whats supported by my printer. So I also attached a slightly smaller version (_um2).

Print Settings

Printer Brand:

UltiMaker

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p><a rel="nofollow" href="https://ultimaker.com/" target="_blank">Ultimaker 2+</a></p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>30%</p></div></p>                                                    <strong>Filament:</strong> Avistron PLA

Tesla Model S Center Console Tray Drawer