Summary

This is an angle stop with parameters for angle, length, reference position (up, down, and on either non-hypoteneuse side), and reference position standoff from the angle (in mm).

My use case was to set a fence on a chop saw to an arbitrary angle for exhaust pie cuts.

You can adjust the parameters in openSCAD using the .scad file, and then re-exporting a new STL.

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>CR-10</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20%</p></div></p>                                                    <strong>Filament:</strong> Amazon Basics PLA                red                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Lay it flat away from the angle, that way you can print without supports.</p></div>

Parametric angle stop