Ram antenna removal tool

The stock antenna on a Ram truck uses a 8mm or 5/16" spanner wrench. I wanted something that would not mar the metal and could be kept in the glove box so I could remove when going through a car wash. It works ok, but I had to make the dimensions slightly off from the actual part due to printer inaccuracy. You may be able to print as is or scale it slightly smaller if your printer is more accurate.

I found that a metal spanner (either 8mm or 5/16") were slightly too large and would tend to mar/round the antenna. There are plenty of 8mm spanners for SMA connectors here, but they will deflect and slip if the antenna is tight. This box style seems to work very well but I've only used it once so far.

I printed 100% infill but I suppose less might work.