Lego Man Head bored out

Remixed from the one referenced.

Bored it out using SW to save material.

The top of the bore is a 50 degree cone so it doesn't need support internally.

Set your overhang threshold to 55 deg.

200u layer height

Only 8 to 10% infill required (use lines/zigzag)

Takes about 4h to print out using S3D

I did it on an Ender 3 S1 using PETG because that was the only stuff I had in yellow.

v2 is the mega bored out version which is hollow all the way thru vertically. You may prefer this one.

Enjoy!!