Accurate Lethal Company Wearable Cosplay Helm-MK3

-MK-3 Company Helm

• Standard Issue IAW COMOPNAV1738-2169-PPE-SYSTEMS
  GROUND USE ONLY, NOT VOID RATED
  *For a Different Modular Design, with Oxy Tanks, check out https://www.thingiverse.com/thing:6348204
  by Company Engineer TrigoKlei

  Helmet Starts off Small, but grows bigger in your [Slicer] of Choice!
  Print the helmet with the head hole facing upwards.

GENERAL HUMANOID MEASUREMENTS

15-15.9x=S | 16-16.9x=M | 17-17.9x= L |
"Size up 14.5-15X in [Slicer] for very Small Adult Heads, Younger is smaller than that, i would use the HELM SIZE TEST Cutout i made with Meshmixer, see if it goes past your head to your neck snugly without hurting"

COMPANY ENGINEER NOTES:

• " My head is an XS, which is why i printed like 3 different Size test rings, and then adjusted to around 15X size, and made the X axis a little wider than 15 to Accompany my Much-More-than-normal Cranial activity and ~Superior~ Brainwaves"
• " You are going to sand and then Glue the Earcups to their Obvious places on the Helmet, dont screw this up if you want to breathe on other Planets than Terra."
• "BTW, Booleans, in Blender, were used to make screws cut their screwholes into the earcup model."
• "I made bolt cutouts for the specific Steel bolts i already have, but there is a Plain version, and a Version that will print with Bolts Merged Solidly"

Extra Notes:
-Paint with Liquid Black Rubber Sealant When issued for better Full Rubber Seal.
-Consider making a Leather or TPU RUBBER (preffered) Circular Neck seal, the built in holo-seal may not work in up to 30% of Issued Helmets, but that is not worrying, so Don't.

Ear Protection Foam with Comfort Pads / Oxygen System / Mic/Amp/Earphones Communication Assembly/ Helmet Pads / Shock Foam Assembly Sold Separately.
-Please Bring Extra funds to the Company Building on Contract Signup!!